Simulation end time:
Simulation end temperature:
Initial time step for automatic control:
Maximum time step for automatic control:
Manual step width for manual control:
Increase factor for manual control:
Isothermal temperature/Start temperature: Enter the desired temperature for an isothermal treatment. If continuous temperature control is selected, enter start temperature in this field.
T-dot: Heating/Cooling rate for continuous temperature control.
from table:
from heat treatment:
Temperature in Celsius:
Maximal T-step:
Result buffer:
Append to buffer:
Update output every:
Iteration:
Linear time step width:
Log time step factor:
No action:
Reset precipitates:
Load from state:
Convergence control: